Maintenance method of Belt condensation granulator

Belt condensation granulator is a commonly used granulating equipment in China, with simple structure and convenient operation. It is very important to use and maintain the Belt condensation granulator correctly. The following editor will introduce you to the use and maintenance of the Belt condensation granulator.

Belt condensation granulator is a key equipment in feed production. The application of new technology has greatly improved the efficiency and quality of pelleting. With the continuous development of the feed industry and the continuous improvement of the country’s requirements for feed quality, the Belt condensation granulator has become more and more important in the development process. We should focus on technological innovation to better meet the pelleting needs and promote better development of the feed industry.
1. Lubricate the transmission part of the granulator regularly, lubricate the roller bearing every 2 hours, and lubricate the front bearing of the main shaft every 4 hours to ensure the flexible rotation of the transmission part of the granulator and reduce the work load.
2. Regularly replace the lubricating oil in the gear box of the granulator. The oil needs to be replaced once after half a month of operation of the new machine. After that, it must be replaced every 1,000 hours of continuous operation, which can extend the service life of the gear.
3. Once a week, you must carefully check whether the connecting parts of each part are loose, whether the travel safety switch is reliable, and clean the feeding auger and the conditioner to avoid mechanical failure.
4. Check the wear of the transmission key, the compression mold liner and the hoop every half month. The belt condensation granulator manufacturer will tell you to replace it in time if the wear is found, so as to avoid the shaking of the ring mold and affect the output.
5. Use ring die and pressure roller. Choose the compression ratio of the ring die according to different formulas to ensure the smooth output of the ring die and avoid increasing power consumption and reducing production capacity.
6. Adjust the gap between ring die and pressure roller every shift. If the machine is blocked, the pressure roller must be loosened, the gap between the mold rollers must be readjusted after the material on the inner wall of the ring die is removed, and it cannot be forced to start, so as to avoid damage to the transmission part and bearing gear due to severe vibration.
7. Put an end to overload production. The manufacturer of Belt condensation granulator tells you that during the production process, the working capacity of the granulator itself should not be exceeded, otherwise the motor will be damaged and the components will be accelerated wear and tear, which will shorten the service life of the granulator.
8. The belt condensation granulator manufacturer tells you that the raw materials must be cleaned of iron and impurities, and the iron removal device should be cleaned every shift to prevent foreign matter from entering the ring mold pressing room, causing vibration of the machine body and cracking of the ring mold.